Remote Operator
Remote Operator enables you to use a PC to view and work with a remote controller's HMI panel.
You can define any number of controllers, then open multiple sessions to view them simultaneously, while docking or cascading windows according to your preferences.
84 topics in this forum
-
- 3 replies
- 168 views
-
- 0 replies
- 85 views
-
- 3 replies
- 608 views
-
- 3 replies
- 427 views
-
- 1 reply
- 212 views
-
- 12 replies
- 424 views
-
- 4 replies
- 438 views
-
- 0 replies
- 183 views
-
- 7 replies
- 683 views
-
- 4 replies
- 521 views
-
- 1 reply
- 453 views
-
- 1 reply
- 534 views
-
- 3 replies
- 744 views
-
- 1 reply
- 795 views
-
- 1 reply
- 1.4k views
-
- 1 reply
- 1.1k views
-
- 1 reply
- 1.3k views
-
- 4 replies
- 1.3k views
-
- 0 replies
- 1.3k views
-
- 4 replies
- 1.2k views
-
- 3 replies
- 1.3k views
-
- 3 replies
- 2.3k views
-
- 3 replies
- 1.3k views
-
- 5 replies
- 1.5k views
-
- 0 replies
- 923 views
-
Member Statistics
8,493
Total Members1,206
Most Online
-
Topics
-
-
Who's Online (See full list)
-
Posts
-
By JRiddington · Posted
Hi guys, I have now tried starting a new project. Absolutely no ladder at all. I have still got the analog outputs directly wired to the analog inputs. Output 0 to input 0, and output 1 to input 1. I have scaled both inputs and outputs in the I/O settings to have a range from 0 to 10000, they are also both set to 0-10v. I created a watch table for all 4 (analog input 0 and 1, and analog output 0 and 1). If i understand correctly, if i send analog output 0 to a value of 1000 i should get 1000 back on the input? This is not the case i appear to get a value of 340 on the input. How can this be possible? The scaling is the same and one is directly connected to the other. I have checked the voltage and that appears to be correct just not the value of the input. -
Why aren't you using Layers? You can hide an entire layer while editing the HMI, so you won't have to send to back or bring to front. -
I followed the instructions to make a factory reset SD card but the tool's standard software still launches. It does read that there is an SD card inserted with the software though. Not sure if there is a jumper or some other reset function I'm supposed to engage first. -
By Joe Tauser · Posted
Yep. Subroutines are the way to go. You're on the right track. Joe T. -
As Gabriel said - how is your input scaled? Try linearizing the input over the voltage range you want. This will linearize a 14bit analog input over the 0-1000 mV range you need - setting input voltage equal to bar essentially. 2v = 2bar, 10v =10 bar
-
-
Blog Entries
-
