DataXport and DataXls
Sign in to follow this
Followers
0
DataXport creates logs of run-time or stored data from Data Tables and operand regions within Unitronics PLCs. DataXport saves the data logs in .ulp format. You can open these data logs using DataXport's companion application, DataXls, and then export the data to Excel files.
37 topics in this forum
-
- 0 replies
- 24 views
-
- 12 replies
- 185 views
-
- 4 replies
- 150 views
-
- 0 replies
- 104 views
-
- 4 replies
- 175 views
-
- 3 replies
- 226 views
-
- 3 replies
- 228 views
-
- 1 reply
- 658 views
-
- 3 replies
- 606 views
-
- 0 replies
- 276 views
-
- 0 replies
- 345 views
-
- 1 reply
- 528 views
-
- 0 replies
- 362 views
-
- 1 reply
- 439 views
-
- 4 replies
- 801 views
-
- 1 reply
- 714 views
-
- 1 reply
- 607 views
-
- 3 replies
- 1,017 views
-
- 1 reply
- 565 views
-
- 1 reply
- 636 views
-
- 1 reply
- 553 views
-
- 2 replies
- 1,187 views
-
- 8 replies
- 1,133 views
-
- 5 replies
- 1,301 views
-
- 3 replies
- 1,281 views
Sign in to follow this
Followers
0
-
Member Statistics
-
Topics
-
-
Who's Online (See full list)
There are no registered users currently online
-
Posts
-
Did you try actually measuring the current with multimeter? -
If you don't see I 0 on when you go online with the PLC then you have a wiring problem with your input. If a Set coil latches, then it means the input flickered on so rapidly that you couldn't see it.
-
Is it n/p input on jazz setup corectly? Please see in installation manual. -
Hello everyone, I'm having a problem with Vision V1040, Details are given below. 0 S. (Stop Mode - Fatal Error) Enum: Ox00000801 IP: Ox00348C18 00365C2C Ldr: Ox0000001C Desc: Undefined Opcode whenever our client is running motor, mostly this error is coming out, sometime PLC + HMI is running normally but mostly it ended up with this error, I think this error might be caused by noise of VFD, 0-10V signal to VFD is supplied by V200-18-E6B Snap In I/O module. so I want a solution for this, I can use signal isolator for 0-10V supplied from PLC to VFD to isolate the signal. but I wanna know if their is any solution can be done without using external components or devices. -
Hi, I am using a current simulator to input a 4-20mA signal to AI0 of a IO-A14-AO2. The raw data is doing the opposite of what I am expecting. As I increase the current, the raw data decreases, and visa-versa: the value of MI 0 goes down as mA input signal goes up. I tried reersing the signals but it does not work either - do you have any idea what may be happening here? I tried it with both current and voltage signals.
-
-
Blog Entries
-
