Vision & Samba PLC + HMI Controllers & VisiLogic Software
Welcome to the Vision and Samba series forum
Talk about issues related to the Vision and Samba PLC + HMI series and to VisiLogic software
3,895 topics in this forum
-
- 6 replies
- 105 views
-
- 2 replies
- 86 views
-
- 1 reply
- 66 views
-
- 4 replies
- 100 views
-
- 0 replies
- 60 views
-
- 22 replies
- 5.1k views
-
- 3 replies
- 81 views
-
- 1 reply
- 81 views
-
- 13 replies
- 523 views
-
- 10 replies
- 249 views
-
- 1 reply
- 70 views
-
- 7 replies
- 2.3k views
-
- 1 reply
- 72 views
-
- 1 reply
- 71 views
-
- 3 replies
- 348 views
-
- 8 replies
- 263 views
-
- 15 replies
- 269 views
-
- 0 replies
- 52 views
-
- 8 replies
- 263 views
-
- 0 replies
- 50 views
-
- 8 replies
- 221 views
-
- 0 replies
- 94 views
-
- 9 replies
- 257 views
-
- 3 replies
- 162 views
-
- 1 reply
- 77 views
-
Member Statistics
8,492
Total Members1,206
Most Online
-
Topics
-
-
Who's Online (See full list)
-
Posts
-
By JRiddington · Posted
Hi guys, I have now tried starting a new project. Absolutely no ladder at all. I have still got the analog outputs directly wired to the analog inputs. Output 0 to input 0, and output 1 to input 1. I have scaled both inputs and outputs in the I/O settings to have a range from 0 to 10000, they are also both set to 0-10v. I created a watch table for all 4 (analog input 0 and 1, and analog output 0 and 1). If i understand correctly, if i send analog output 0 to a value of 1000 i should get 1000 back on the input? This is not the case i appear to get a value of 340 on the input. How can this be possible? The scaling is the same and one is directly connected to the other. I have checked the voltage and that appears to be correct just not the value of the input. -
Why aren't you using Layers? You can hide an entire layer while editing the HMI, so you won't have to send to back or bring to front. -
I followed the instructions to make a factory reset SD card but the tool's standard software still launches. It does read that there is an SD card inserted with the software though. Not sure if there is a jumper or some other reset function I'm supposed to engage first. -
By Joe Tauser · Posted
Yep. Subroutines are the way to go. You're on the right track. Joe T. -
As Gabriel said - how is your input scaled? Try linearizing the input over the voltage range you want. This will linearize a 14bit analog input over the 0-1000 mV range you need - setting input voltage equal to bar essentially. 2v = 2bar, 10v =10 bar
-
-
Blog Entries
-
