UniStream: Hardware
This is the place for all things Hardware: UniStream HMI panels, CPUs, I/O and COM modules
317 topics in this forum
-
- 0 replies
- 720 views
-
- 12 replies
- 1.9k views
-
- 6 replies
- 321 views
-
- 0 replies
- 114 views
-
- 1 reply
- 95 views
-
- 9 replies
- 2.6k views
-
- 1 reply
- 97 views
-
- 0 replies
- 116 views
-
- 2 replies
- 153 views
-
- 3 replies
- 223 views
-
- 4 replies
- 259 views
-
- 4 replies
- 208 views
-
- 2 replies
- 167 views
-
- 2 replies
- 115 views
-
- 3 replies
- 1.2k views
-
- 2 replies
- 155 views
-
- 1 reply
- 204 views
-
- 9 replies
- 1.2k views
-
- 12 replies
- 4.4k views
-
- 1 reply
- 185 views
-
- 6 replies
- 362 views
-
- 2 replies
- 623 views
-
- 2 replies
- 261 views
-
- 9 replies
- 357 views
-
- 0 replies
- 195 views
-
Member Statistics
8,493
Total Members1,206
Most Online
-
Topics
-
-
Who's Online (See full list)
-
Posts
-
By JRiddington · Posted
Hi guys, I have now tried starting a new project. Absolutely no ladder at all. I have still got the analog outputs directly wired to the analog inputs. Output 0 to input 0, and output 1 to input 1. I have scaled both inputs and outputs in the I/O settings to have a range from 0 to 10000, they are also both set to 0-10v. I created a watch table for all 4 (analog input 0 and 1, and analog output 0 and 1). If i understand correctly, if i send analog output 0 to a value of 1000 i should get 1000 back on the input? This is not the case i appear to get a value of 340 on the input. How can this be possible? The scaling is the same and one is directly connected to the other. I have checked the voltage and that appears to be correct just not the value of the input. -
Why aren't you using Layers? You can hide an entire layer while editing the HMI, so you won't have to send to back or bring to front. -
I followed the instructions to make a factory reset SD card but the tool's standard software still launches. It does read that there is an SD card inserted with the software though. Not sure if there is a jumper or some other reset function I'm supposed to engage first. -
By Joe Tauser · Posted
Yep. Subroutines are the way to go. You're on the right track. Joe T. -
As Gabriel said - how is your input scaled? Try linearizing the input over the voltage range you want. This will linearize a 14bit analog input over the 0-1000 mV range you need - setting input voltage equal to bar essentially. 2v = 2bar, 10v =10 bar
-
-
Blog Entries
-
