Jump to content

Recommended Posts

Hi,

 

I'm sure this is a simple problem...

 

I have a project written for the V1210, I am attempting to debug the ladder and want to step through it once cycle at a time. The manual seems to suggest this is possible but I cannot get this to work. I have placed an "on line point" in the ladder, built and downloaded the code. Then connected using "online Test". Page 213 of the ladder manual says that execution will "freeze" when the scan hits the on line test point, but it doesn't appear to, the program continues normally with timers counting down etc.

 

The on line test point is connected to the power rail so I would expect it to be "On", do you have any suggestions ??

 

Thanks in advance

 

Pete.

 

 

 

 

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...