Jump to content

Problem with ethernet, V1040 and V200-19-ET1


Recommended Posts

Hi, I have a problem with ethernet-connection, the PLC is V1040 with V200-19-ET1 -ethernet card.

 

I've been using ethernet-connection with Samba (Modbus TCP connection to SCADA software) and it worked fine!

 

The problem is, that when I plug ethernet cable from v1040 to ethernet switch, switch seems to have no activity. Not even Link/act -leds doesn't turn on.

 

When I keep touch screen pressed and enter setup, it show MAC address and IP of ET1, so PLC recognizes that there's ethernet card installed.

 

I've been trying another PLC and another V200-19-ET1, different ethernet switch, different cables, even straight connect to my laptop with cross-connected cable with no results. No activity in ethernet connection.

 

What am I doing wrong? Does V1040 have jumpers that are needed to change?

 

 

Link to comment
Share on other sites

Hello,

 

Thank you for using our Unitronics Forum.

 

Are you able to ping the IP address of the device from your PC while it is connected?  If the device is disconnected, could you ping the IP address anyway?

 

Are you sure the PC and your device is on the same network (same first three octets of IP address)? 

Link to comment
Share on other sites

No, PLC doesn't response for PING. PLC's IP is set to 192.168.171.135 and my laptop 192.168.171.136. Just tried with cross-connected cable. In fact, my PLC says "no network cable connected". PLC's information mode says "card initialized" and "link lost, auto-recover is off".

 

As said, I have also tried another ET1-card and another PLC. Could there be a compatibility problem between software or hardware versions of PLC and ET1?

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...