lawry

Thank you Ausman The blue spanner icon is a DELL support alert to carry out a hardware scan. Will try your suggestion A Happy Christmas to you and all the others in the Unitronic's family

I installed V9.8.65 on the 15th of December, 2017, since then, every time I use Visilogic, i get the prompt as displayed in the picture attached. I can get round it by clicking cancel twice, but its annoying. Please Help!

As per help file, the function on rung 5 should be of equal and not of unequal as is in your case

Thanks Flex. Will adopt this.

No Joe, i prefer Win7

I started working again on V9.8.64 on another laptop, and the same behavior was occurring. All my projects are saved to Google Drive. I turned off Google drive and that behavior stopped. This never happened with previous versions

Flex, Thank you for your reply. Re installing V9.8.64 on my Win7, 32 bit laptop, got rid of the Run-time error. Whenever i worked on a project on any prev versions, as a force of habit, I would periodically save my file (overwrite on the same file). Here in V9.8.64, every time that i try to do so, I'm prompted that another program is using the file, and that the file should be renamed. I would then save it as filename_x.vlp. It would then save it. Now i did this and saved my latest file and took a coffee break. On resumption, the latest file opened with the work that was done 2 days back, even though the time stamp of saving was just half hour back. Now i have un installed V9.8.64, installed V9.8.31, but alas i cannot open the file i was working on. Now Ive resigned to rebuilding the project from scratch

V 9.8.64 SUCKS! Even after saving the file with different names, I lost out almost 16 hours of programs. Creators, don't be fooled that this is a stable version. Had much better luck with previous versions

Hi, After installing V9.8.64, I'm facing 2 peculiar problems. Whenever I try to modify the properties of any HMI image, i get a message Run-time error `9': Subscript out of range. And secondly If I try to save an existing project, it doesn't allow to do so. I have to save it as a different file name every time.

In audio electronics, this was necessary, as the shield would usually be connected to the analog ground and would not be necessarily earthed. Whereas in industrial applications, the shield would best be earthed at one (preferably the source) end and have no connection to any Vcc grounds.

Mike_uz, please call hmi display "My Display" in main routine

Have you set your addresses in the respective MIs?

It may work if you shift RESET MB49 after the Store Direct block

Have you configured the required jumpers in both the PLCs?