Jump to content

Leaderboard


Popular Content

Showing content with the highest reputation on 08/19/2016 in all areas

  1. 1 point
    Thanks for the tip HigHTech. I will try and use that example in my ladder. The application has changed a bit though. Instead of using a 0-10V input, a sensor will be used and a setpoint will be set. If the value is higher than the set point, the pulsing of the output begins. For example, if I have a P-band of 5 degrees, at 2,5 degrees, the pulses will be at a maximum and above that, another output gets activated and the pulsing starts over until 5 degrees above set point is reached.
×
×
  • Create New...