Jump to content

dylan

Members
  • Posts

    9
  • Joined

  • Last visited

dylan's Achievements

Newbie

Newbie (1/4)

0

Reputation

  1. hello Just a quick question ? trying to read a MI from V570 on to a Scada program if you are in scada and want to read MI3 would that be labeled as 00003, (int) because MB3 is 0003. im just wanting to display a running value??? i have read the forum and the webinars .,just can get it to work?? any help would be great thanks dylan
  2. Hi Joe i have been trying to connect using one of the modbus drivers that comes with citect 7.3 . im not sure if its compatible with windows 8? citect forum says it should be compatible, but it just wont connect. i think it must be something im not doing correctly. dylan
  3. Hello can anybody help me . I'm trying to set up comms between citect 7.3 and a Unitronics 570. Do i have to run it between UniOPC and the HMI or can i connect direct..also what address would you label MI 2 for example when compared to MB 2.. I have looked at a great video file on the forum already,but im still getting an error on the Scada. i can send a copy of my program if it helps?? dylan
  4. Hi joe At first i assumed the transducer was unstable, but after discussion with a lecturer and testing with a Druck it has been suggested turbulence is the problem. This is because of the setup of the rig is measuring Air flow. i have fitted a baffle to counter act this and the output is still varying from 1.1 volt to 1.5 volts at a steady input flow . Can i place 2 filters before the linearization and would you expect this to work? Dylan
  5. hi there Just wanting some advice. I have a pressure transducer fitted to a Venturi tube for my college project. I have a output range of 0.25 v to 4v output. Only problem being is the output is jumping all over the place, is there a method of using filters to stabilize the output so i can use p.i control. regards Dylan
  6. still not working... have loaded 9.6 but now just displays- Run-Time error 70
  7. Hi can anyone help. my version of 9.6 will not install on properly on my laptop. just says "9 permission denied" i have put up a photo of the message. dylan
  8. hi eyals thank you so much for the reply, i will have a look and try to correct the problems. will keep you posted. dylan
  9. Hi Can anybody Help i'm a student just starting to use the V570, and i have just a quick question Can you set an MB to output a mA output to a control valve? the set up consists of a pressure transducer which inputs a 0.25 - 4 volt input to the plc, then i wish to convert this input to produce an output of 4-20mA which operates a control valve. I also have a maintenance screen which i want to operate the control valve independently to the input.( i.e. press a button on the h.m.i and open the valve 25%,50%,75% and 100%) is this possible. Picture attached below. thanks dylan( S.I.S==Stressed Irish Student ).
×
×
  • Create New...