Jump to content

Martin Sirovy

Members
 View Profile  See their activity

  • Posts

    5

  • Joined

  • Last visited

 Content Type 

Everything posted by Martin Sirovy

  1. Martin Sirovy
    The conclusion from Unitronics support - probably HW issue. However I tried it for the last time today before sending back and the calibration past with no problem. The only difference I see I did not have so dry fingers today as last time.
  2. Martin Sirovy
    Thank you Flex727, I have sent the message on the support email as well, I will report here the conclusion. Martin.
  3. Martin Sirovy
    Dear Support team, I have the Unistream US5-B10-B1 OPLC. The factory default touch screen calibration is bad, hence I used the Touch Screen Calibration command from the Uniapps menu. It usually worked well, however on this peace of hardware after touching all the 5 points, it writes "Calibration Failed" and recommends to do it again or restart...I have tried it sereral times with the same result. Any recommendations? Thank you, Best regards, Martin Sirovy.
  4. Martin Sirovy
    The problem is solved - I did not noticed, that the minimal frequency in HSO mode is 6 Hz. Thank to the support for a fast response.
  5. Martin Sirovy
    Hello, I have Unistream 7 and I have problem with configuration of high-speed output of module UIS-WCB2. The high speed output 0O should be able to be configured up to 250 kHz using PWM mode. According to help, I have configured in properties windows HS Block 1 to PWM - see screenshot. Then I have configured the struct B1 according to the screenshot, but it still does not work. The classical "slow" output using function PWM worked, however I can not get to work the high-speed 100 Khz+ output mode. Thank you very much for any tips. Best regards, Martin Sirovy.
×
×
  • Create New...