I'm working on my first CANopen project where a frequency drive is controlled using the Vision 1210.
However i can't seem to figure out how i can start this drive. According to the CAN Bus Operation PDF i should be able to control the drive using PDO 1, as it's default mapping is the control command register. To start the drive bit 0 from register 2000 must be set. but how can i set bit 0 using canbus?
Vision 1210 Canopen communication with Fenner QD: Neo drive.
in Vision & Samba PLC + HMI Controllers & VisiLogic Software
Posted
Hello,
I'm working on my first CANopen project where a frequency drive is controlled using the Vision 1210.
However i can't seem to figure out how i can start this drive. According to the CAN Bus Operation PDF i should be able to control the drive using PDO 1, as it's default mapping is the control command register. To start the drive bit 0 from register 2000 must be set. but how can i set bit 0 using canbus?
CAN Bus Operation.pdf
FENNER_QDNEO_S2-S3_CANopen 2.00.eds