Jump to content

ahodges

Members
  • Posts

    3
  • Joined

  • Last visited

Everything posted by ahodges

  1. Joe, thanks for the quick response! I feel like I am close, but when I press F2, the cycle does not start. I intended to start(F1)/stop(F2) and be able to resume where I was or clear the count and start from the beginning. Also I don’t think my times are set up correctly, but I’m not sure until I actually apply it to the application since it’s hard to tell from just the valve lights.Cycle Help.vlp
  2. Hello! I am trying to create a program that will extend a cylinder for 10 seconds with valve 1, retract after the 10s and have a running count of the cycle after it is retracted. While doing this, I want valve 2 to ‘dump' the air after valve 1 has been on for 5 seconds so there is no pneumatic force in the extend position after the initial 5 seconds of valve 1 opening. Is this possible? Any insights would be greatly appreciated! I am using VisiLogic to write my program and V130-33-T2 hardware. Please advise!
×
×
  • Create New...