Hello everyone,
My name is Dave Wilson, I own a small phone case company based in the UK.
I have recently just invested into a new Sublimation machine that requires heat and vacuum pressure in order to create a personalise effect to one of our case types.
I have purchased this machine and with no help from the supplier, struggled setting up and figuring out how to work the thing. All I do know is the machine is not heating up enough to complete the transfer process.
To cut a long story short, I've been looking into this and realised it was programmed with a unitronics PLC.
I need someone to help me figure out how to change temp control and vacuum pressure via the PLC?
I have tried contacting the supplier several times with no avail. I understand you can insert a sd card to transfer the data table and adjust temps, when I do so it comes up with "password missing" and does not let me transfer any data except from hardware. I am a complete novice when it comes to this kind of thing and just need some help.
I have navigated into system and seen the name Maurice as the programmer name. There is a Maurice118 on this forum which may just be a coincidence, but it would be nice to find out if it was him who programmed this machine. I'm thousands of pounds out of pocket and just need some help so I can feel like I havent been conned.
Any help would be much appreciated.
Kind Regards
Dave