Jump to content

richie

Members
  • Content Count

    9
  • Joined

  • Last visited

Community Reputation

0 Neutral

About richie

  • Rank
    Newbie
  1. I checked again and cannot see anything that could be interfering with this action.
  2. I am trying to do a direct store from ml 1 to ml 2. When i do this it does not put the value from ml 1 to ml 2. does anyone know why?
  3. that is what i meant to say is 10 columns and 9999 rows. Can I make one data table,store it on a sd card and read/write from the sd card?I have tried to build the data table but it says it is to big when i try to save, but i havnt had a screen to try saving it to a sd card.
  4. I have a 1040 screen I need either 9999 data tables are one data table with 10 rows and 9999 colums. what is the easy way of doing this?
  5. I need a data table that has 9999 rows. My problem is it takes up to much memory in my 1040 hmi. So if i bought a sd card to put the data table in could i read and write to the sd card or does the hmi load the table from sd card and put in hmi.
  6. THANKS I HAD THE INPUT SET UP FOR HIGH SPEED COUNTER . WHEN I CHANGED IT TO SHAFT ENCODER X2 IT COUNTED UP AND DOWN. MY ENCODER ONLY HAS A (A SIGNAL) WILL IT BE OK TO USE SHAFT ENCODER X 2 FOR THIS ?
  7. my dispay is only counting up. i need it to count up and then count down. i think i may have something set wrong when i set up the high speed counter. any ideas?
  8. I loaded my project on 1040 hmi with v200-18-e3xb module, all my inputs work but none of my outputs work. i tried just a simple program and still nothing. I can monitor the program and it shows that the output is on but the relay never close. this is all new hardware any one got a clue. i think it is just a bad v200 plug in module.
×
×
  • Create New...