Search the Community
Showing results for tags 'master'.
Found 4 results
behator posted a topic in Jazz, M91 PLCs and U90LadderHi, I have a problem with aplication. My Jazz should works a few minutes as Master after that switch to Slave mode ( in the loop). It works, I switch to Slave mode till set SB25 (Ethernet Connect / Listen Request), after that Jazz turns to Master (write 0 to SI214) ??? Someone can help me ?
Ljuba posted a topic in Vision & Samba PLC + HMI Controllers & VisiLogic SoftwareHi, I have Unitronics PLC V130-J-TR20 PLC, which is a master, and two Jazz JZ20-J-T40, which are slaves. I need two of the slave Jazz PLC's to communicate with master V130 PLC. I have made configuration in PLC Program for read and write, but it's not working properly. When i set bit for request to read PLC3 (MB100), it reads it normally. But, when i try to read PLC2, it reads same value that I have on PLC3, although Communication is OK with PLC2. I have read example project, and used it to configure communication between PLC's, like you can see in the images. Regardless of what I do, one of the PLC's is not working properly, communication says it's OK, but keeps reading values from other PLC. IP addresses are different, of course, and i have typed them correctly into the MODBUS IP Configuration, like in the image. On my Jazz PLC's I have done everything like Example project in U90 Ladder says. Is there a way of fixing this? Thankful Nikola Ljubinkovic
kilca posted a topic in Vision & Samba PLC + HMI Controllers & VisiLogic SoftwareHello again, since your answers are very helpful and I could not find information I need on this forum, I`m starting new topic. I need to set up communication between V280 and multimeter DMK 22 by Lovato. Here is the tutorial they sent me: https://www.sendspace.com/file/trigbh(file is too big to be attached here on forum) I have several problems with understanding the whole communication. I have working MODBUS IP communication between PLC-to-PLC, where the communication is done through MODBUS R/W Mix, which I understand how it`s done. Here I need to get from the slave multimeter 3 values. First question: How do I send message to slave? The message should looke like this: 08 04 04 00 00 00 64 63 6A, do I have to send it as vector of HEX MIs? And the message I get back from slave will be vector too? If you don`t mind to explain this a little bit detailed including a little tutorial how to set it up correctly in VisiLogic, I`d be very happy. I have to solve this in 2 days. Thanks in advance a lot! Unitronics community is great and I will surely write it down to my thesis and recommend you. Best regards, Martin P.
Vivianaors posted a topic in Vision & Samba PLC + HMI Controllers & VisiLogic Softwarehi, I have a project and require communication between a ABB drive and V280 unitronics, where v280 is the master, anyone can help me or suggest how I start? thanks, pd. I have done this type of communication but with other brands, this brand only cut I made the flight program without communication inputs and outputs only analog and digital.