Search the Community
Showing results for tags 'no application'.
Found 1 result
I have attached images to this post below... Basically I haved a V570 (with the ethernet addon) which was last used about 5 years ago. When I powered it up, I got a no loaded application error. I have tried going into visilogic, with with default baud rate settings, and the settings shown on the display, but i just cant get access to it. I also am using a 4 wire RJ11 cable ( I have no programming cables left). Could this be the issue that I cannot connect? Or is it because the PLC is in stop mode? I have tried connecting via ethernet, but my lan adaptor wont let me use the subnet mask that the PLC is showing (it says that it is invalid). Many thanks, Roy.