Search the Community
Showing results for tags 'remote i/o'.
Found 3 results
Hello, I have a project connecting some new I/O to a vision 350 through an EX-RC1. The Vision 350 will then transfer some of the data to a Vision 1040 PLC. In the project it will be a EX-RC1 -> IO-AI4-AO2 ->IO-DI16 on one den rail in a panel. I believe all I need is some devicenet cables to connect the EX-RC1 -> Vision350 PLC -> Vision1040 to communicate through CANbus. Would there be any other hardware or items required besides power wires and the programming cable for the 1040 and 350?
Hy I just got the first glimps at the EX-RC1. Shure the first thing I did was upload the factory-installed program and took a look at that. That's where the error came. Right before finishing upload from EX-RC1 Visilogic 9.5 gives me an error "Warning 202 - This operation will not be completed due to Compilation errors." Compile gives me error 66 in subr. IN net 6: "Before UniCAN Send, High Priority, Use -|\|- of SB 201. Before Low Priority use -|\|- of SB 202." Now program being made in VisiLogic 7.0.1 (gives me warning during upload about it) It tought it might have something to do with that. Still - I'm a little in a hurry wich means I'm trying to get my job done relying on Unitronics team and their factory-installed program. Since I have to configure analogue I/O 's I have to know if the program I'm downloading with the new HW configurations IS the correct, full and working program. Thank you all for your help!