Search the Community
Showing results for tags 'remote'.
Found 4 results
Dear colleagues, i need some support concerning the remote control with an iPhone. My connection is not really stable. I connect the iPhone and after 10-60 seconds the connection fail and I cannot connect to the PLC anymore. So I have to disconnect to the WLAN connection and connect ones more and then it goes, but again only 10-60 seconds. So the question is whether it is an iPhone problem or a general problem with the connection. Or do i have to change the router adjustments? Another oddness is that it is only possible to connect if the IP adress is 192.168.1.1 and this is the same as the router ones. it is a riddle to me how this works. Maybe I need an iOS update? I am thankful for every guess. Best regards Fabian
Hello, I am planning to buy a V1210-T20-BJ and mount it in a panel door. I want to connect it to 3 x IO-DI16's and 3 x IO-TO16's that will be mounted on a din rail inside the panel. What is the module I should use to connect them and what cable should I use?
Hi there I was using remote operator for a new v700 install When I went to enter a value onscreen the remote operator was using a different keyboard layout to the PLC and so couldn't enter the value correctly Photos attached for reference taken of PLC and remote operator, any insight would be appreciated also I am using the latest Remote Operator 22.214.171.124
Hello! I have V560 and Netgear wnce2001, the idea is to make a wi-fi connection and using the connection to download programs from PC to PLC. Netgear is setted up to use static IP and it is connected with V560 using LAN cable, Ethernet card is added to the PLC. Unfortunately, I have some unclear points. Firstly do I need to use TCP/IP Card Init and how to set up the block? The parameters (IP, Subnet Mask, Gateway) inside the TCP/IP Card Init must be equal to the parameters inside Netgear? Do I need to use TCP/IP Socket Init and TCP/IP Connect/Close? Thanks!