Jump to content

Recommended Posts

This is my first post so I didn't have the time to introduce myself. Anyway I am starting my first project with a V570 and an snap in IO card in order to monitor and control the process of a drying oven. I viewed the corresponding webinars and I think I got the main idea about Visilogic (My previous knowledge about ladder and PLC programming is minimum).

 

Anyway when I insert a configuration PID FB in my project and trying to compile the code, I get the error mesagge that PID Config is not supported by Color PLC or/and V130-33. Am I missing something too obvious ? 

 

Any help is welcome,

 

Thanks in advance,

Share this post


Link to post
Share on other sites

The truth is that the program was at its very best beggining ( - |SB2| - PID Config ). So there wasn't much to send. Fortunately I already got a reply from Unitronics support and the problem is already solved.

 

The solution is that I had to use the functions blocks (for run PID, configuration, etc) from PID Autotune menu rather than the PID menu.

 

Anyway the project is proceeding and I am sure that I will come up with other questions for help and advice. So, stay tuned :) .

 

Thanks a lot for the interest Joe.  

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

×
×
  • Create New...