Jump to content
Sign in to follow this  
curtharrington

Active Loop and Passive Loop

Recommended Posts

Hi all,

    I put together a project with a v570 controller and a E3XB snapin module.  I have two anaolg inputs (AI1 & AI2).  AI1 has a loop powered signal for a pressure transducer hooked up and AI2 has a self powered signal coming from a pH meter hooked up.  We noticed that the two inputs seemed to not play well with each other because when they were both hooked up the pH meter reading would come in at less than 3.4mA.  It seemed like they were fighting with control of the refernce ground so we installed a signal isolator that takes a 0-10V (all we had at the time).  The customer is complaining that the value on the meter doesn't match up to the value displayed on the PLC and this has to do with converting the 4-20mA (only option for retransmission).  If we can, we would like to eliminate the signal isolator.  Any input would be greatly appreciated, thank you

Share this post


Link to post
Share on other sites

Hello,

 

Unfortunately, at this time Unitronics controllers do not support loop powered devices which is likely why it is not reading correctly. Is it possible use a true 0-10V or 4-20mA sensor to replace the one originally for analog input 1?

Share this post


Link to post
Share on other sites

In general terms you can use a loop-powered device with Unitronics if you include a loop power supply in series with the loop.  It is simple if there is only one analogue device connected.  However in this case you may still get problems with the reference ground, depending on the overall circuit for your second analogue signal.  

 

If it's not a simple case of switching sensors as Alex suggested, I would put a signal isolator on the loop-powered sensor.  Either purchase an isolator with support for loop-powered sensors, or add a loop supply to the sensor circuit.  Adding the loop power supply in this case should not affect the reference ground as the isolator is between the PLC and the loop supply.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

×
×
  • Create New...