Jump to content

Recommended Posts

Hello!

Another one topic PLC/E-mail. Unfortunately, I'm not able to copy with the problems.

 

I use the ladder from Example (of course). In CMD I write "telnet pop.gmail.com 25" and I can see the protocol type used by the server. After that i tape "pin pop.gmail.com" and see the IP address of the server. 

The first change that I make in the ladder is IP in "TCP/IP - Tcp connect" block. The new IP is the same as IP address of the server. 

The second change is in the "E-mail" block. "From:" e-mail is Support@unitronics.com and the receiving e-mail is "..........gmail.com". When I press "connect" in HMI the system is able to connect. However, when I press "Send E-mail" there are two mistakes: "The server cannot receive data (DATA mode error)" and "From address format incorrect " I have tried many settings but non of them was workable. Please, give me an advise where might be the mistake! 

 

Share this post


Link to post
Share on other sites
2 hours ago, Joe Tauser said:

 

This is an old thread.  Are you having a problem?

Joe T.

Yes, My original problem was similar to this one, but I have since been able to send email. However, it is not consistent. Many times I get an error about there being an issue with my password, other times, as soon as the 'send email' bit goes true, it closes the socket connection for some reason. I can try to send an email over and over again and get very inconsistent behavior. I am using gmx over port 587.

 

I posted a new topic about it here, 

But i hadn't gotten any bites yet, so I was looking around at other posts.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...