Jump to content

Recommended Posts

Hi, I'm a new user and I've been trying to get a PTO pulse signal from one of the high speed outputs of my V130-33-TR34 to send to a stepper motor driver. I just got the PLC so it's set to default jumper settings.

 

I pretty much followed the webinar on the Unitronics site and I'm pretty sure I did the wiring right (pin 1 on the transistor outputs to driver, pin 5 to PLC ground). Hooked it up to an oscilloscope and I don't get anything out. When I run the PTO move command, it turns the MB on for "PTO Move Success."

 

Tried going into the HW Configuration and trying to get a PWM signal out by setting up one of those and initializing Frequency to 500, Duty cycle to 500 (50%), and then downloading a program with just ---|SB2|---(MB0)(S) where MB0 is the PWM "Run Bit" and still nothing. Anybody see something simple I overlooked or something I did wrong? If not, any ideas what might be going wrong? Thanks in advance

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

×
×
  • Create New...