radovan Posted February 10, 2016 Report Share Posted February 10, 2016 Dear all, I want to connect JZ10-T18 with MJ20-PRG module to Modbus Gateway, because I want to establish communication to the PC over Ethernet. Gateway has Ethernet TCP port : 192.168.1.1 - Router_EthernetPort.bmp. Gateway has RS232 port adjusted as you can see on picture Router_SerialPort.bmp. Ethernet card on PC side adjusted like on picture : TCP_IP_settings.bmp. Also, I configured UniOPC as you can see on picture : UniOPC_Settings.bmp. You can see PLC program on picture : JAZZ10_prg.bmp. When I connect OPC Client to the UniOPC and add Item "PLC1.STATUS" I get as result : "Communication Fail". I am not sure what could be problem. If somebody confirm me about PLC program is it ok? Or maybe I need MJ20-RS module? Tomorrow I will get MJ20-RS modul. Also, pin out for the Gateway RS232 port is : 1 - RTS 2 - DTR 3 - TXD 4 - GND 5 - GND 6 - RXD 7 - DSR 8 - CTS and I ceonnect to MJ20-PRG : RS232 pin 1 to pin 6 MJ20-PRG RS232 pin 2 to pin 1 MJ20-PRG RS232 pin 3 to pin 3 MJ20-PRG RS232 pin 4 to pin 2 MJ20-PRG RS232 pin 5 to pin 5 MJ20-PRG RS232 pin 6 to pin 4 MJ20-PRG JAZZ10_prg.rar Router_SerialPort.rar Router_EthernetPort.rar TCP_IP_settings.rar Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.