Jump to content

Recommended Posts

I am having problems getting any output or input from a V200-18-E4XB attached to a V570.  I believe the wiring is correct and power is being supplied to all the appropriate places.  I also believe the jumpers are set properly. AO to B, AI to A.

 

SB 177 shows that the snap in module is installed and responds when the module is removed.

 

The AI always shows 32767. 

 

When using a volt meter to measure output voltage of the AO, I never get more than a few mV not matter what values is written the to output register.

 

I also tested a DO without success.  

 

Is there a definitive way to determine if the snap in module is damaged?  .

 

 

Thanks for your time.

Share this post


Link to post
Share on other sites

Any chance it's set to current versus voltage?

 

Or it's completely missing some jumpers?  It sounds like you have done everything ok, but perhaps you didn't have one of the plugs fully inserted, which you corrected in fitting the new module?

 

cheers,

Aus

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

×
×
  • Create New...