Jump to content
Ichirou

reading Janitza UMG104 over Modbus RTU fails by float?

Recommended Posts

Hi there,

i'm not able to read 32bit float big-endian from Janitza UMG104. Connection is over COM1 in Modbus mode, periodic trigger activated by pushbutton and set slave-name (bit) to 1.

This works fine for the Modbus TCP slave, which provide me system information. The powermeter i try to read, deliver me important informations which i later need to add together with sensor values to a data table.

Reading fails at the point, the 32bit float comes in.

I tried:

Register addresses 19018 (current, A), 19026 (power, W) and 19034 (power, VA) with own Tags as REAL, with memory float array MF[MF_0] to MF[MF_2], reading the registers from normal table (1639) and with adding address value for little endian communication. Nothing works.

Registers 19xxx provide most used values.

The REAL goes to a REAL to INT converter, ouput is INT32.

A try with GridVis and Janitza Modbus Diagnostic tool works fine, all 3 Register addresses with reading 4 bytes.

When i take a look the the online state of the memory floats, i see flickering data.

I will try the swap bytes extended, but i hope, you have generally an idea, what goes wrong and how i can fix this.

Pictures follows later, when i'm back to work :)

Enviroment: Janitza UMG104 (latest firmware), Unistream USP-156-B10 (latest firmware), Com1 38400/8/n/1 Modbus periodic, Modbus Slave ID 1.

(yes, I'm new to PLC/HMI)

BR

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...