Jump to content
Sign in to follow this  
cmarcus

Fastest Communications between PC and PLC

Recommended Posts

Hi,

I have  a customer that is looking to use a Unitronics PLC to add additional outputs to their existing system.  The main system runs on a .net application, so the PLC would be mainly used to set/reset a MB or Output at a particular time.  The response time needs to be pretty fast, likely a few milliseconds from PC send to output state change.

Which communication method would be the fastest or would they be roughly the same?

- PCOM

- .NET driver

- Custom protocol with short command sent from PC and received via FB protocol scan.

Just getting a feel on how I should build the PLC communications class.

Thanks,

Share this post


Link to post
Share on other sites

the .Net driver implements the PCOM.

There is a little overhead of the fact that it is written in .Net (Ctor, GC, JIT compilation, threads and locks), so I can't give you an accurate time on how much  it takes to send a message to the PLC (Assuming you already established a connection to the PLC).

It also depends on the channel (Serial or Ethernet, and if Ethernet then also the distance between the PC and PLC).

 

Modbus is also a fast protocol.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

×
×
  • Create New...