Jump to content

Recommended Posts

Hello,

I have to configure a Vision 700 . The software was successfully  installed.

Is it possible to change the contrast and brightness of  the display. 

It would be great, if anybody can help me in changing the contrast and brightness, I was not able to find anything about that point.

Thanks in advance

Regards

Anoop

Share this post


Link to post
Share on other sites

Hi,

You can change the backlight intensity using system integer 9. The values is between 0 -100.

0 - off

100 - full

  • Upvote 1

Share this post


Link to post
Share on other sites
1 hour ago, jedft123 said:

Is there not a built-in screen config page with these types of settings?

No, there's not, but you can adjust SI9 directly through INFO Mode and it will retain that setting unless the PLC is initialized or the battery fails.

Share this post


Link to post
Share on other sites

I use the following logic to achieve a screen sleep function for backlight's life economy.

If MB26 is enabled by a toggle button on the screen, screen sleep function is on.

If the screen has not been touched for a preset amount of time, the value of SI9 is set to zero and backlight turns off.

When the screen is touched, backlight turns on.

 

 

 

si9.PNG

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...