Jump to content
Sign in to follow this  
Sevenfins

Program Assistance

Recommended Posts

So, I'm new to Unitronics and pretty much PLC in general, and I am doing a project for school. I have everything else complete in it (To the best of my current knowledge) with the exception of:

The program calls for a fan to ramp up to whatever speed when the heat in the furnace reaches a certain degree,

and the fan is supposed to run in forward and reverse during the duration of the wash cycle. 

I have looked for help and have yet to find any on my end, thus why I turn to the internet. Any explaination would be great. 

Share this post


Link to post
Share on other sites

I'm assuming the fan is on a VFD.

The fan ramp can be done with a linear block driven by an MI counting time. What is the ramp rate?

After the fan reaches speed, use two timers alternating each other to trigger the reverse input on the drive.  I'm also assuming you've programmed accel and decel times in your drive to handle reversing the fan.

If you're not too shy to post your code it would be very helpful.

Joe T.

 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×