Jump to content

Recommended Posts

Hello Unitronics.

Help Center Eduardo Margulis 19th Nov. 2017 wrote:

Configure the CANbus port using a COM init function set to CANopen + J1939.

Note that the ECU adress used by theJ1939 protocol is the Vision Unit ID number, which is contained in SI 8 when COM init runs.

After the COM init function, place the J1939 Configuration function. This has three tabs comprising the parameters listed below.

Note that the status parameter, J1939 Configuration startup process status provides status messages for all tabs in the Configuration

QUESTION: Tab name, what is the configurations parameters for my V570 Plc ( 64 bit or 8 bytes ) The Plc is only to communicate with one (1) diesel engine.

Thank you.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...