Jump to content

Recommended Posts

Hi!
This weekend something was happening with a well-functioning plc, what do you think was the trigger?
These pictures were sent from him, before restarting, and restarting.
You may have been disconnected through the modbus connection?

újraindítás előtt.jpg

újraindítás után.jpg

Share this post


Link to post
Share on other sites

The application software was lost. Is the battery good? Check the battery and the power supply, then reload the application from VisiLogic or an SD card. To prevent this, do "Download All & Burn" when downloading the application.

Share this post


Link to post
Share on other sites

I've got the same problem as this. I replace the batterie and I redownload the application in the PLC. It do the same thing again. Can you help me with that please! I do the Download All & Burn but it don't remember my last paramaters when I restart it...scuse me for my English, I courently speak French...

Share this post


Link to post
Share on other sites

Hi Rel, your english is better than my french!  Please clarify.....is there a "no application" message like in the above screenshots, or is the application there but it has lost the previous parameters? 

7 hours ago, ReIYeL18 said:

it don't remember my last paramaters when I restart it

These are 2 different problems.

cheers, Aus

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...