Jump to content
Interroga

Why initial cycle bit blink during work?

Recommended Posts

I've never seen this happen, but have you tried any troubleshooting? I would place an increment function just after the Power-Up contact to see if it's really passing the power flow. If so, then I would create an additional line with just the Power-Up and Increment function to see if they both do it. If not, I would delete the troublesome line and re-create it.

Share this post


Link to post
Share on other sites

i put  one increment and verify this problem. I see too the clock in screen blink sometimes.

I hope the plc dont go to stop this cenario.

Thanks for your reply.

 

regards, mauro. 

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...