Jump to content
Sign in to follow this  
ORSO2001

Replace retained tags with DTI Struct tag...

Recommended Posts

dears All,

I will have to modify an old project where I used a lot of retained tags (was my first project and I was not very skilled...for sure worst than now 😁 )...I want to replace the retained tags with a struct referred at a DTI...then save this on the SD.

my question is...if I will upload a new project , the same but with more UDFB-tags etc, the retained tags that are used at the moment still contain the same value or will be reset?

just to know if I can do this without problem, because I will also update the PLC version, or if I have to think something to save the retained tags and upload these later.

thanks

Share this post


Link to post
Share on other sites

Hi,

As I understand you are going to  add more tags/structs to the project. In this case the existing retained tags should not lose their values.

Anyway I suggest to backup your project and the retained tags using UniLogic or UniApps.

If you are upgrading firmware then I highly recommend to backup the retained tags.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

×
×
  • Create New...