Jump to content

Recommended Posts

Can someone show me an example of code that causes the plc to go into sleep after 30 seconds and Kinda go into a idle screen. Only stuff I see examples on is in visilogic

but can someone help me out and do it in   unilogic? I'm sure it is simple but I am very new to this.

Share this post


Link to post
Share on other sites

You would run a timer activated by an inverted contact of the General.Touched bit. Use the Out bit of the timer to trigger an Action to change screen brightness.

Share this post


Link to post
Share on other sites

You may want to make an action to jump to another screen and then when  the screen is touched jump back to the last display.   This way no buttons you have on the screen are activated when filming out of sleep mode.

Share this post


Link to post
Share on other sites
5 minutes ago, Cam said:

You may want to make an action to jump to another screen and then when  the screen is touched jump back to the last display.   This way no buttons you have on the screen are activated when filming out of sleep mode.

This is good advice.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...