Jump to content
Sign in to follow this  
ORSO2001

Set point value on PID autotune

Recommended Posts

Dears,

is possible, during the PID autotune procedure, change the set point value?

I mean...if I select "Cycles.Three" the procedure will increase to reach, and go over, 4 times the set point and also decrease 4 time to be below of the set point....is possible set (pass) for each of these 4 steps a different set point?...for example 70, 90, 110, 130?

in this way the autotune procedure will be "masked" in what could be a standard start up of the system.

thanks

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

×
×
  • Create New...