Jump to content
Sign in to follow this  
Ausman

V130 with microSD inserted makes PCB access difficult

Recommended Posts

Hi all, recently had to change some internal modules/configs in a 130.  Pulling the PCB was far more difficult than I was used to, and made me stop and reassess.  This was a 130 that was already in use, and I found that I had left the microSD card in place.  This protrudes enough to not let the pcb glide past the normally easy gap.  Removed the card and things were ok.

Moral of the story......Always ensure the MicroSD is out of a unit before doing any internal work.  I know this is a very limited scenario, as most times this access is done during first install, but felt it worth noting here.  The same thing might apply to a host of other models.

cheers, Aus

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

×
×
  • Create New...