Remote Operator
Remote Operator enables you to use a PC to view and work with a remote controller's HMI panel.
You can define any number of controllers, then open multiple sessions to view them simultaneously, while docking or cascading windows according to your preferences.
69 topics in this forum
-
- 1 reply
- 71 views
-
- 1 reply
- 84 views
-
- 2 replies
- 192 views
-
- 0 replies
- 291 views
-
- 4 replies
- 322 views
-
- 3 replies
- 316 views
-
- 3 replies
- 454 views
-
- 3 replies
- 308 views
-
- 5 replies
- 491 views
-
- 0 replies
- 219 views
-
- 5 replies
- 331 views
-
- 5 replies
- 277 views
-
- 6 replies
- 601 views
-
- 4 replies
- 488 views
-
- 17 replies
- 1.2k views
-
- 5 replies
- 562 views
-
- 7 replies
- 515 views
-
- 6 replies
- 799 views
-
- 18 replies
- 2.2k views
-
- 9 replies
- 2.2k views
-
- 5 replies
- 873 views
-
- 11 replies
- 739 views
-
- 1 reply
- 1k views
-
- 3 replies
- 992 views
-
- 1 reply
- 595 views
-
Member Statistics
5,906
Total Members501
Most Online
-
Topics
-
-
Who's Online (See full list)
There are no registered users currently online
-
Posts
-
Further to Kratmel's good advice, it is worth saying that many modbus things will not communicate to Visions at greater than 9600. It is always worth starting slowly and trying bigger baud rates after getting things working ok in the first place. I also note you have 2 stop bits. ?? I'd also make your timeout bigger, along the lines of the previous baud rate comment but in this case it is start big and reduce. Why, and how, are you working MB107? cheers, Aus -
HI, Please send your request to support@unitronicvs.com B.R. -
Hi, try this checklist: - wire swap A & B; - check - is it V700 and Energy Analyzer correct in master-slave mode; - configure com port and disable all modbus send net. Connect V700 A&B wires to PC - Energy Analyzer RS485net. Go to info mode and try monitor RS485 packets via V700 com port. If you see something correct than port and speed connection is OK. - try to activate Modbus and check via Info mode - what is go from V700 and from Energy Analyzer; - try to use single Modbus command activated by button and check Modbus status. As i see you try to read MF 44 direct via modbus. On forum is present topics with Energy Meters float read via Modbus issue - maybe in your case some tips and tricks with two MI to MF convertion needed. Please post Energy Analyzer model. -
Hi All, A new 10.1" models required by Vesp123 already at site! Visit and review! B.R.
-
By CatUnitronics · Posted
Have 3 separate test stands that are Unitronics USP-156-B10 that are not on a network. Would like to see about sending data from the Unitronics to 1 Allen Bradley PLC. Would this be feasible? Thanks
-
-
Blog Entries
-
