Remote Operator
Remote Operator enables you to use a PC to view and work with a remote controller's HMI panel.
You can define any number of controllers, then open multiple sessions to view them simultaneously, while docking or cascading windows according to your preferences.
69 topics in this forum
-
- 3 replies
- 1.6k views
-
- 7 replies
- 2.1k views
-
- 0 replies
- 221 views
-
- 5 replies
- 565 views
-
- 0 replies
- 293 views
-
- 3 replies
- 1.8k views
-
- 3 replies
- 2k views
-
- 4 replies
- 1.5k views
-
- 1 reply
- 2.2k views
-
- 1 reply
- 1k views
-
- 1 reply
- 1.2k views
-
- 6 replies
- 3.5k views
-
- 1 reply
- 1.1k views
-
- 1 reply
- 1.3k views
-
- 2 replies
- 989 views
-
- 1 reply
- 596 views
-
- 2 replies
- 1k views
-
- 2 replies
- 1.2k views
-
- 2 replies
- 2k views
-
- 1 reply
- 697 views
-
- 11 replies
- 1.2k views
-
- 1 reply
- 1.3k views
-
- 8 replies
- 2.2k views
-
- 4 replies
- 323 views
-
- 4 replies
- 840 views
-
Member Statistics
5,913
Total Members501
Most Online
-
Topics
-
-
Who's Online (See full list)
There are no registered users currently online
-
Posts
-
No, screen react only for 0.2-0.5sec. and i can only change System, Network, Utilites menu but no information prsent. Connecting frame run on screen. UniApps start not posible. All touch is interrupted by Connecting frame. Also try with mouse... no result. -
Hi Kratmel; Can you get into the UniApps from the Screen and check the VNC Settings? DanT -
USP -070-B10 panel used as VNC client started with black screen. I prepare recovery DOK with 1.28.58 firmware as this version it used for program PLC with the same panel+CPU as server. After sucessfull recovery - USP -070-B10 show Connecting frame and do not connect with server PLC. I try to disable VNC client mode but as i see it is not possible. Connecting frame still on screen. I can select System, Network, Utilites at time approx 0.5 sec after start and Connecting screen lock all function. Machine work with server PLC but remote panel do not work now. Maybe something wrong with settings now but i can't chane it. Unilogic say Download and Online mode are not supported for USL and Unistream PLC's acting as ones. Any idea? Maybe i lost something in manual or help? How to disable VNC on USP? P/S Change firmware for another version do not change panel behavior.
-
By TJ Houston · Posted
My apologies, this set up on the down stream device is modbus RTU, however, it uses a rj45 connection. We would be using a gateway RTU -> TCP into the PLC/HMI combo. Here is the long and short of it. We currently get this set up from a supplier. It takes them 8+ weeks to get one out to us. I figured if we can get a scalable program set up, delivery times would decrease considerably. Thus, making for a happier customer. -
dear TJ, some not clear info from you...I mean...you wrote about ModBus TCP but the document attached report, for these devices, ModBus RTU by RS485...have you a gateway in the middle?
-
-
Blog Entries
-
