Jazz, M91 PLCs and U90Ladder
Talk about issues related to Jazz, M91 PLCs, and the U90Ladder software
492 topics in this forum
-
- 2 replies
- 919 views
-
- 1 reply
- 1k views
-
- 1 reply
- 1.5k views
-
- 2 replies
- 1.4k views
-
- 1 reply
- 1.1k views
-
- 2 replies
- 1.3k views
-
- 2 replies
- 973 views
-
- 1 reply
- 1.1k views
-
- 11 replies
- 4k views
-
- 1 reply
- 1.2k views
-
- 2 replies
- 898 views
-
- 0 replies
- 892 views
-
- 2 replies
- 1.3k views
-
- 4 replies
- 2k views
-
- 2 replies
- 948 views
-
- 2 replies
- 1k views
-
- 2 replies
- 814 views
-
- 1 reply
- 2.6k views
-
- 1 reply
- 1.1k views
-
- 2 replies
- 1.2k views
-
- 1 reply
- 823 views
-
- 1 reply
- 1.6k views
-
- 2 replies
- 1.3k views
-
- 1 reply
- 5.5k views
-
- 5 replies
- 4.6k views
-
Member Statistics
8,493
Total Members1,206
Most Online
-
Topics
-
-
Who's Online (See full list)
-
Posts
-
Keep in mind that the analog inputs are 14 bit (0-16383) and the analog outputs are 12 bit (0-4095). So if you use the same scaling or linearization for both, it will not be 1 to 1. -
Today's date digits can be fun to play with in the various formats in use. 🙃 -
By JRiddington · Posted
Hi guys, I have now tried starting a new project. Absolutely no ladder at all. I have still got the analog outputs directly wired to the analog inputs. Output 0 to input 0, and output 1 to input 1. I have scaled both inputs and outputs in the I/O settings to have a range from 0 to 10000, they are also both set to 0-10v. I created a watch table for all 4 (analog input 0 and 1, and analog output 0 and 1). If i understand correctly, if i send analog output 0 to a value of 1000 i should get 1000 back on the input? This is not the case i appear to get a value of 340 on the input. How can this be possible? The scaling is the same and one is directly connected to the other. I have checked the voltage and that appears to be correct just not the value of the input. -
Why aren't you using Layers? You can hide an entire layer while editing the HMI, so you won't have to send to back or bring to front. -
I followed the instructions to make a factory reset SD card but the tool's standard software still launches. It does read that there is an SD card inserted with the software though. Not sure if there is a jumper or some other reset function I'm supposed to engage first.
-
-
Blog Entries
-
