RBC

Hi. If you run the vision software not in administrator mode it gives same problem. I've set mine up now to run as adminstrator always and no more errors like that. Hopes it helps.

Hi. My network comprises of 6 V570 plc's using raw udp to communicate. IP addresses from 192.168.1.100 / 101 / 102 / 103 / 104 / 105. At this stage all plc's broadcast anytime. I need a sequencer to make sure they only broadcast one after another acording to ip address. Lets say we start ip 100 to send, then if 101 receive the data from 100 he must send to all and so on. I've attached the program recived from unitronics to set up my network. I've tried various compares and moves but every now and the the network get stuck that way. I will apreciate any help in this regard. Thanks. UDP Raw broadcast PLC1_V570.vlp

Hi. If i stop the drum sequencer all outputs stay on instead of turning off if drum is not active. Is it a fault on fb or not. I would imagine that if you stop the drum midway, it should turn off all outputs and reset to stage 1 if started again. Thanks.

Hi. I've got an application at my client that have 5 stages running on preset timers. Now my client wants to be able to run the fans in forward and reverse direction. He want to set the percentage the fans must run in the reverse direction. Lets say the stage is 5hrs and he want to switch on the for/rev funtion. Then i must work out how much time is left of the timer on work out lets say 20% and put that value in the reverse timer. is it possible or must I change the timers to counters? Thanks for your help.

Hi. thanks. I'll add the canbus card to my v350. Then i'll install the expantion card with the additional cards. how will i address the canbus cards.

Hi. Just want to find out about adding a canbus module to excisting v350-35-ra22 with various modules added to system. Will my addresses change and how do i go about. First time that i need to work with canbus network expantion. Hope u can help. Thanks