wyx

Ok. Found out that there are 16 jumpers to set. But other than the jumpers, is there any thing else need to be set before and after new IO Module installation?

Hi, I am new to almost every thing here. It just happen that my equipment which uses Unitronics "V230" PLC and "V200-18-E3XB" IO Module is down due to 5~10degC temperature fluctuation from a RTD sensor. I am seeking for advices from the experts here. Below drafted is the configuration: RTD sensor ported into a cooling water pipe --> Analog IN terminal "AN1" of E3XB --> V230 As of today, we have replaced the RTD sensor and V230, but it didn't fix the fluctuation. Our next plan is to replace the V200-18-E3XB IO Module, but we are not sure if there's any set up or configuration need to be done prior to install this module. I have been searching for this info in the web for hours, but found nothing. Thanks