Buddy123

Hi I am trying to connect a Samba PLC to a SEW MDX61B VSD via Ethernet and using Modbus TCP. Using the function blocks in the Samba program I can get it to connect to the SEW VSD but when I try and read an address which the SEW guys say is correct, 8320 which is the encoder position it shows a status fault code of 7. I can connect the same program to a Jazz PLC and read an address in it. The Samba is the Master and SEW the slave, can someone help, I think it looks like a case of just the wrong address or maybe an extra number before it Thanks Phil

Hi Has anyone got some knowledge with reading the Public IP address on a Unistream PLC, I am wanting to record what the public IP is at any time into my program. Regards Phil

The camera is a TECHview, these are the specs and I have attached a file with a couple of screen shots from the camera software Specifications: Image Sensor: 1/3” CMOS, 2.0MP Resolution: 1080p (1920 x 1080) D1 (720 x 576) CIF (352 x 288) Frame Rate: 1080p @ 25fps (Single Channel) D1 @ 25fps (Multi Channel) CIF @ 20fps (Mobile) Min Illumination: 0.03 Lux @ F1.2 Video Format: AVI (H.264) Lens: 3.6mm Fixed Focal Infrared: 30 x IR LED’s Network Interface: 1 x RJ-45 10/100Mbps IP Rating: IP66 Power: 12VDC, 1A / Power over Ethernet (PoE) Dimensions: 150(L) x 63(Dia)mm Camera details.pdf

I am trying to set up an IP camera to a Unistream 15 panel, it comes up with an internal error (Resource error) on the screen when run, the help file says the camera settings need to be compatible but I cannot find any detail as to what these should be, can anyone help with some information. Regards Phil