Arun

Vision 230 Controller showing below alarm can you explain meaning of this

it s possible to change I/O configuration from Expansion module to Snap module without Communication cable. we have V230 PLC , 6 DO connected with solenoid coil in SNAP I/O module and it was worked , we have expansion DO module also and its not used , weeks before we did reset after PLC hanged , after reset PLC automatically snap I/O not worked same time expansion DO channel 6 started to service , all wiring connected to Snap I/o , there is any way without communication cable possible to change I/O configuration from Expansion module to Snap module

can you explain how to configure 4 pin RJ 11to RS232 DB9 female pins for use V230 unitronics

Hello All we bought new V230 Controller with default program , the old one configured 5 DO Channel for Snap I/o module but new one working with I/o expansion module , how we can change configuration expansion module to snap module ?