Hi All, I was trying to connect Moxa ioLogik E1214 to Unistream USP-070-B10 over EtherNet IP. The Connection Status shows error code "0117", which explained as "Invalid Produced or Consumed Application Path". I created this node using "Add Node From EDS" file. I used the EDS file provided by the Manufacturer. I can see very short period of connection because the device name shows up correctly on the field, then disappears. Can anyone help me on this issue?
I have a LoPy device as shown in the link below: https://pycom.io/hardware/lopy-specs/ I also have the Unitronics US5-B10-TR22. I am trying to connect US5-B10-TR22 to LoPy via Silicon Labs CP210X USB to UART Bridge. I enabled the Panel USB Port as TX/RX from Physical-Controller USB Port. Then I used Com TX to send data to LoPy as shown below and I also attached the simple code I wrote. But I never succeeded sending any data. The Com module gave me error code -1, which is general com error. I never programmed Unistream before and I am just learning. Can I communicate to LoPy via