Manville
-
Posts
2 -
Joined
-
Last visited
Content Type
Profiles
Forums
Gallery
Events
Blogs
Downloads
Articles
Media Demo
Everything posted by Manville
-
My original thought was to have the PLC start up with a set voltage (let's say 7 volts) and delay 15 seconds to give the fan time to get up to speed and establish some pressure in my chamber. My photohelic will then switch based on it being too low or too high. I would use this switch to tell my program to now add or subtract 1 volt to my current output voltage. Once the fan is between the set point both switches will be open and nothing changes until my pressure drops or gains. I was hoping this could be done with a simple program. Maybe I am wrong.
-
I have a Dwyer Series 3000 Photohelic and would like to control a 24volt fan. I am thinking I can use the high level and low level switches to control my voltage. I need a program that will slowly step up the current voltage if the low level is hit and slowly step down the current voltage if the high level is hit. I am extremely new to PLC programming and I have looked through the sample programs and still have no clue. :-) I have an M90-TA2-CAN controller. Any hits or ideas?