Hello, I'm quite old for the Unitronics ladder, but mainly in Jazz.
I am having the same issue with my V130-33-TR34, all the programming side should be okay, only a sample application trying to get it to work - go to target with given velocity in PTO.
It is configured, I set the profile and the succes bits are on both, but then when issuing the Move it only sets the succes bit on, but the stepper motor doesn't budge.
My wiring is such: O1 and O3 to PUL + and DIR + of the stepper driver (through 2k resistor since it has 24V), then the PUL - and DIR - to 0V on the PLC. I have tried to switch the PUL and DIR from + to - and the 0V too, but no luck.
When reading position from Read PTO block, it starts moving, but also my target is 2500, units and pulse/unit are 1=1, but the read position stops at around 4290 - 4320 values.
Can somebody explain how am I supposed to wire/program/change something on my setup so I can get it going?