Jump to content

Ruslan

Members
 View Profile  See their activity

  • Posts

    10

  • Joined

  • Last visited

 Content Type 

Everything posted by Ruslan

  1. Ruslan
    Thank you. When I check I'll let you know about results
  2. Ruslan
    Yes, you right. Version 9.8.91 PLC_4_V51.vlp
  3. Ruslan
    Hi JPG, I've got PLC V350 and URB-TCP - 2pcs. URB-TCP- I connected to 0 and 2 socket of V350. But If I load programm for 1st URB, after 2nd URB, then 1st is disconnect. If I load 2nd URB, after 1st URB, then 2nd is disconnect. Could you give me example, please, how you made it? I think that I've got issue with settings of connection in ladder
  4. Ruslan
    Thank you for link. But I mean not URD-TCP2, I mean URD-TCP - 2 pcs. located in 2 different places. Can I connect URD-TCP- 2 pcs. to PLC. PLC has only 1 socket № 0 for URD connection. May be has a decision how connect 2pcs. of URD to PLC?
  5. Ruslan
    Hi all , I've got a PLC V350 and 2 URB-TCP with discrete and analogue inputs/outputs modules. How do I configure this in Visilogic?
  6. Ruslan
    You are right, of course we use physical buttons and duplicate an alarms with lamps, in case the PLC fails. Unfortunately, I have a V350 PLC - 3 pieces that are out of order.
  7. Ruslan
    Thanks, but this is not the finished version. L and H are pre-alarm conditions, in case of manual operation. Between L and H is the working mode, which I set to Start / Stop. Still, I would like more features in the VisiLogic graphic editor.
  8. Ruslan
    My PLC model is V700. I had to spend a lot of time on the primitive. The level bar has placed on top of the pumps and between the pipes. But I'll be think, how make better, because I want make level bar was from 0 to top. display.bmp
  9. Ruslan
    Thanks for the answer. I've got a task. I need to graphically show the state of a submersible pumps, wet installation in water. The pump has 3 statuses: gray - normal condition, green - running, red - emergency condition. Water shows the level higher or lower. As a Pump I am using "List of images", and Level of water using "bar". Unfortunately they doesn't overlap. But I have no other ideas how to show submersible pump in water, so that it would be intuitive and graphically understandable, and nice
  10. Ruslan
    Request to the developers, improve the graphical interface in Visilogic. I can't overlay images on top of each other, I can't move any image to the top or end of the page. To draw a pump with changeable statuses in the water level using a bar, I need to waste a lot of time. Not working return action - Ctrl+Z. And many other problems with creating pictures and animations in HMI.
×
×
  • Create New...