Search the Community
Showing results for tags 'fatal error'.
Found 2 results
-
Hello everyone, I'm having a problem with Vision V1040, Details are given below. 0 S. (Stop Mode - Fatal Error) Enum: Ox00000801 IP: Ox00348C18 00365C2C Ldr: Ox0000001C Desc: Undefined Opcode whenever our client is running motor, mostly this error is coming out, sometime PLC + HMI is running normally but mostly it ended up with this error, I think this error might be caused by noise of VFD, 0-10V signal to VFD is supplied by V200-18-E6B Snap In I/O module. so I want a solution for this, I can use signal isolator for 0-10V supplied from PLC to VFD to isolate the signal. but I wanna know if their is any solution can be done without using external components or devices. -
Fatal Error V350
Augusto posted a topic in Vision & Samba PLC + HMI Controllers & VisiLogic Software
Hello Everyone. Hello everyone I am having a problem with my Vision V350, in the company where I work there are two PLCs, a V350 and a V1210 that communicate by MODBUS. We have a screen that alerts us when a communication problem happen and when we check our V350 it shows us an error that is: O.S. (Stop Mode - Fatal Error) Enum: 0x00001740 IP: 0x00250000 00076A2C Ldr: 0x000000DE Desc: Undefined Opcode Some changes had been made to the program and then this error arose so it went back to the previous program, but the problem is still happening. Does anyone have any idea why this happens? By performing a reset of the equipment, the problem is solved momentarily but this is not recommended for our production.