Search the Community
Showing results for tags 'reset'.
Hello, if someone can help me it would be great! I just got the V-570 PLC and had it wired up to my inputs and outputs, and wanted to test it out. I have two issues I need to fix: First I tried to upload my project to the SD card, and put it in the PLC and run it. I wanted to see if I could just do basic screen navigation first. However, when I ran the program, after clicking on the first screen, it glitched out and turned a solid blue with no buttons. I figured it was a coding error on my part, but how do I take the program off of the PLC and restore it to the little animation sequence it had when I first turned it on? When I turn the maching off and on again it just goes back to the solid blue screen I had before. The second issue is, i figure to stop this from happening again I can debug it by the online test mode. However, when I followed the instructions to install the drivers and plugged the USB in, it said the port was not open and "may be used by another application". Is this a network firewall issue? I've attached the screen that comes up. If someone can help that would be great, I'm new to all of this and worried I might break something if I try to fix this myself. Thanks in advance!
Hi everyone! Is there any way to reset the MI associated to an HSC input by software? The problem is that if I don't do that, it will overflow. Thanks in advance, Gonzalo PS: I'm using a V350
Dear Friends, In dryer I changed CMOS battery... After that it working normally.I can set my values as like before replacing CMOS battery... When I start the machine I can't see thee temperature on display.It simply showing ****.****like How to solve this problem..?
Hi I am a newbie to Visilogic and I am really sturggling to reset me TD timers to the preset value after they have counted down (in this case 15 seconds). I have attached a screen shot of the visilogic screen of my current configuration of the timer. Please can someone help and tell me what I am doing wrong as I am pulling my hair out! Thanks Russ