Good morning. I am trying to print messages using the send protocol from a Vision120 to an epson lx350 dot matrix printer. I have the Com Init command and the protocol config command setup.
I have it wired up correctly (I believe) from the RJ11 to RJ45 to the DB25 adapter to plug into the printer.
This system has worked in the past, I inherited the project from a customer who's controls engineer left, and now I'm stuck on getting the printer to work. I have downloaded the program and HMI config and they are working fine.
Does anyone have experience in something similar to this? Is there something on the printer side I have to do?
Let's assume that I have the communication wiring 100% correct. I still have to verify that again in the morning.
Thanks a lot,
Adam McCormick