Search the Community
Showing results for tags 'write'.
Hello again, since your answers are very helpful and I could not find information I need on this forum, I`m starting new topic. I need to set up communication between V280 and multimeter DMK 22 by Lovato. Here is the tutorial they sent me: https://www.sendspace.com/file/trigbh(file is too big to be attached here on forum) I have several problems with understanding the whole communication. I have working MODBUS IP communication between PLC-to-PLC, where the communication is done through MODBUS R/W Mix, which I understand how it`s done. Here I need to get from the slave multimeter 3 values. First question: How do I send message to slave? The message should looke like this: 08 04 04 00 00 00 64 63 6A, do I have to send it as vector of HEX MIs? And the message I get back from slave will be vector too? If you don`t mind to explain this a little bit detailed including a little tutorial how to set it up correctly in VisiLogic, I`d be very happy. I have to solve this in 2 days. Thanks in advance a lot! Unitronics community is great and I will surely write it down to my thesis and recommend you. Best regards, Martin P.
I'm trying to write values and I'm not sure what the binary WRITE message format is, in relation to the READ message format. I couldn't find this answered in the PDF or on the forums yet. I read a summary in the PDF that byte 12 should be changed to 68 and the write values should be appended to byte 32 (which confused me further as that's after the footer checksum). This is what I have for READ: 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 | 24 25 26 27 28 29 | 30 31 32 stx-------------- id FE 01 00 00 00 cn 00 specific--------- lengt chksm | numbr ot FF addr- | chksm ex What would be the correct format for WRITE?